Märksõnad: puldi õpetamine, pult
How to clone your Nice Flo remote control:
1) Press and Hold button 1 and button 2 together - LED will flash 3 times.
2) Keep pressing button 1, press button 2 3 times. Led will start flashing Non-stop. Release the buttons (Led goes off). Now remotes are in pairing mode.
3) Place both remotes Into “Side-by-Side” or “Back to Back” position! Make sure they have direct contact, touching each other.
4) Press and hold one button on your original remote and one button on your clone remote. Keep pressing until led will make : 2 blinks > 3 blinks > Steady = Successfully cloned. Release the buttons and repeate the same thing with another button (remote is still in pairing mode).
PS. You can try those procedures even if the lights don't act the way described in first 2 points. Go ahead to points 3 and 4 and it might just work.
How to clear and clone 2-button remote
Note: most of the 2-button remotes are not programmable!!!!
Clear the code history
1:Press button A and B continuously until LED flash 3 times
2.Release button B (Keep pressing button A),and press button B Slowly for 3 times,LED flash
3.Release button “A”,finish code clearance.
Copy code from original transmitter
Note: you need to clear old codes before you can program new ones!
1. Put duplicator aside of original transmitter,as close as possible.
2. Press and hold button A of original transmitter,then press and hold button A of duplicator until you see the duplicator’s LED flash
3. Release both buttons,finish code copy,copy other button in same way.